Verifying Power - NETGEAR RP114 Reference Manual

Reference Guide for the Model RP114 Web Safe Router

Verifying Power

After connecting the power adapter to the router and a power source, the router powers on
automatically. Complete the following steps to verify that power is correctly applied to the router:
When power is first applied, verify that the PWR LED is on.
1.
Verify that the TEST LED begins to blink within a few seconds.
2.
After approximately 30 seconds, verify that:
3.
The TEST LED is not lit.
a.
The LAN LNK/ACT LEDs are lit for any local ports that are connected.
b.
The WAN LNK LED is lit.
c.
If a LNK or LNK/ACT LED is lit, a link has been established to the connected device.
If a LOCAL port is connected to a 100 Mbps device, verify that the 100 LED is lit.
4.
You are now ready to begin configuration of your network, as described in the following chapter.
2-6 Setting Up the Hardware