NETGEAR RT338 Reference Manual page 225

R
RADIUS authentication, 8-8
rear panel, 2-5
Rem CLID field, Edit Dial-in User, 8-7
Rem IP Addr field
Remote Node Network Layer Options, 5-25, 7-11
Remote Node Profile menu, 7-5
Rem Node Name field, Remote Node Profile menu,
5-21, 7-4
Rem Subnet Mask field, Remote Node Network Layer
Options, 5-25, 7-11
remote dial-in users, 8-1
remote node
configuring, 7-1
setup, 7-2, 7-3
troubleshooting, 12-5
Remote Node Configuration Continued tab fields, 5-24
Remote Node menu tab fields, 5-21
Remote Node Network Layer Options menu, 7-11
Remote Node PPP Options menu, 7-8
Remote Note Set Up menu, 7-3
remote user, troubleshooting, 12-8
Reset ISDN field, Diagnostic menu, 11-10
RFC, xxi
Route Name field, Add/Modify Static Route tab, 5-29
Route Name field, Edit IP Static Route menu, 7-17
router concepts, 1-6
Router Name field, 5-12
Routing Information Protocol, 1-4, 1-7
S
security, 1-2, 1-5, 4-16
serial cable, 2-6
serial port, connecting to, 3-6
Service Profile Identifier field, 5-3
Session Options field
Default Dial-in Setup, 8-4
Remote Node Profile menu, 7-6
Single User Account field, 5-26
Index
Single User Account field, Remote Node Network
Layer Options menu, 7-11
single user account, configuring for, 6-4
software, updating, 11-14
Source field, TCP/IP Filter Rule menu, 9-6
SPID Number(s) field, ISDN Setup menu, 4-9
Starting address field
LAN menu tab, 5-18
static route setup, 7-14
subnet addressing, 1-10
Switch Type field
ISDN menu tab, 5-14
Wizard ISDN Line Setup, 5-3
Switch Type field, ISDN Setup menu, 4-9
Syslog IP Address field, Syslog and Accounting menu,
11-7
syslogd, 11-8
System Maintenance Status menu, 11-3
System menu tab fields, 5-12
System Status Menu, 11-1
system tools, 11-12
T
TCP Estab field, TCP/IP Filter Rule menu, 9-6
TCP/IP
configuration, testing, 11-9
configuring, 3-1
network, troubleshooting, 12-4
Protocol, 11-11, 12-6
requirements, 2-2
using with LAN-to-LAN, 7-2
TCP/IP Detail tab fields, 5-25
TCP/IP Filter Rule menu, 9-5
TCP/IP Setup field, Ethernet Setup menu, 4-14
TCP/IP, configuring, B-1
Telco Options field
Default Dial-in Setup, 8-3
Remote Node Profile menu, 7-6
Telephone Number(s) field, ISDN Setup menu, 4-9
Telnet session, connecting to Manager interface, 3-12
terminal baud rate, 11-5
5