Setting Up Default Dial-In Access; Figure 8-1. Menu 13 - Default Dial-In Setup - NETGEAR RT338 Reference Manual

Reference Guide for the Model RT338 ISDN Router

Setting Up Default Dial-In Access

This section describes the default dial-in parameters. The parameters in Menu 13 affect incoming
calls from all remote dial-in users and remote nodes before authentication is completed.
After authentication is completed, if it matches a remote node, the router uses parameters from that
particular remote node.
To configure default dial-in settings:
From the Manager Interface Main Menu, enter 13 to open Menu 13 - Default Dial-in
1.
Setup as shown in
Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= No
Mutual Authen= No
O/G Username=
O/G Password= ********
Multiple Link Options:
Max Trans Rate(Kbps)= 128
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
Figure 8-1. Menu 13 - Default Dial-in Setup
Enter settings for the default dial-in setup.
2.
Refer to Table 8-1
Press [Enter] at the ENTER to Confirm... prompt to save your selections.
3.
You can press [Esc] at any time to cancel your selections.
8-2
Figure 8-1.
Menu 13 - Default Dial-in Setup
Press ENTER to Confirm or ESC to Cancel:
for information about the fields on the Default Dial-in Setup menu.
IP Address Supplied By:
Dial-in User= Yes
IP Pool= No
IP Start Addr= N/A
IP Count(1,2)= N/A
Session Options:
Edit Filter Sets= No
Configuring Dial-In Access