NETGEAR RT338 Reference Manual page 121

Table 7-1. Remote Node Profile Fields (continued)
Field
Outgoing:
My Login Name
My Password
Authen
Pri(mary) Phone
Number and
Sec(ondary)
Phone Number
Edit PPP Options
Rem IP Addr
Edit IP Options
Remote Node Configuration
Description
This is a required field if Call Direction is either Both or Out. Enter the login name
your router uses when it calls this remote node.
This is a required field if Call Direction is either Both or Out. Enter the password
your router uses when it calls this remote node.
This field sets the authentication protocol used for outgoing calls. Options for this
field are:
• CHAP/PAP—Router tries CHAP when CHAP is requested by the remote node
or PAP when PAP is requested by the remote node (Default).
• PAP—Use PAP only.
• CHAP—Use CHAP only.
Both the primary and secondary phone numbers refer to the number that the router
dials to connect to the remote node. The router calls the remote node using the
primary phone number first. If the primary phone number is busy or does not
answer, the router calls the secondary phone number if available. In some cases
the secondary number is the number your router dials to add additional bandwidth
for a Multilink call. Do not enter 1+area code unless it is required for local dialing.
In some areas, you must enter 1+area code with the number or the call is placed as
a 56K call.
To edit the PPP options for this remote node, move the cursor to this field, use the
space bar to select Yes, and press [Enter] to display Menu 11.2 - Remote Node
PPP Options. For more information about configuring PPP options, see
PPP Options" on page 7-7.
This field is required on all remote nodes except the ISP node. Enter the IP address
of the router at the remote site. A static route is created to the network address of
that router. Note that if the remote network uses a netmask other than the standard
class netmask, you must enter the netmask in the Edit IP Options submenu.
This field edits the parameters of the TCP/IP protocol. Select Yes and press [Enter]
to display Menu 11.3 - Remote Node Network Layer Options. For more information
about configuring PPP options, see
Reference Guide for the Model RT338 ISDN Router
"Editing IP Options" on
"Editing
page 7-10.
7-5