Replacing The Management Ethernet Cable; Figure 46: Console And Auxiliary Serial Port Connector - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide
See Also
Related
Documentation

Replacing the Management Ethernet Cable

146
To connect the new cable, follow these steps:
Plug the female end of the replacement serial cable into the
1.
port (see "Routing Engine Interface Ports" on page
Tighten the screws on the connector.
2.
Power on the auxiliary or console device.
3.

Figure 46: Console and Auxiliary Serial Port Connector

Fiber-Optic and Network Cable Specifications for the M7i Router on page 91
M7i Chassis Description on page 11
FIC Specifications for the M7i Router on page 45
Replacing the Management Ethernet Cable on page 145
Fiber-Optic and Network Cable Specifications for the M7i Router on page 91
M7i Chassis Description on page 11
FIC Specifications for the M7i Router on page 45
To replace the management Ethernet cable:
Press the tab on the connector on the management Ethernet cable and pull the
1.
connector straight out of the port.
Disconnect the cable from the network device.
2.
CONSOLE
145).
Figure 44 on page 145 shows the connector.
Copyright © 2019, Juniper Networks, Inc.
or
AUX/MODEM