Inserting The Compactflash Card; Figure 51: Removing The Compactflash Card - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide
See Also

Inserting the CompactFlash Card

150

Figure 51: Removing the CompactFlash Card

CompactFlash card
M7i Chassis Description on page 11
M7i Midplane Description on page 12
Maintaining the M7i Routing Engine on page 192
Inserting the CompactFlash Card on page 150
Configuring the CompactFlash Card on page 151
To install the CompactFlash card (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
1.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
If the CompactFlash card is in a PCMCIA card adapter, slide it out of the adapter.
2.
Slide the CompactFlash card into the connector on the Routing Engine (see
3.
Figure 52 on page 151).
Use needlenose pliers with grooved jaws to lower and secure the wire clasp.
4.
Install the Routing Engine as described in
5.
on page 142.
Routing Engine (front)
Wire clasp
Figure 52 on page
"Installing the Routing Engine in a M7i Router"
Copyright © 2019, Juniper Networks, Inc.
151):