Configuring The Compactflash Card - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide
See Also
Related
Documentation

Configuring the CompactFlash Card

152
The CompactFlash card will now be the primary boot device.
You can verify correct boot order by issuing the
4.
The output lists the devices mounted. The CompactFlash card is located at
For more information about the command, see the
M7i Chassis Description on page 11
M7i Midplane Description on page 12
Maintaining the M7i Routing Engine on page 192
M7i Chassis Description on page 11
M7i Midplane Description on page 12
Maintaining the M7i Routing Engine on page 192
After installing the CompactFlash card for the first time, you must copy the software
from the Routing Engine's hard disk to the CompactFlash card.
To copy software to the CompactFlash card:
Install the CompactFlash card and replace the Routing Engine as described in
1.
the CompactFlash Card" on page 150
on page 142.
On the console or other management device connected to the Routing Engine, enter
2.
CLI operational mode and issue the following command to copy the currently running
and active file system partitions on the router to standby partitions on the
CompactFlash card.
user@host> request system snapshot partition
Wait until a message appears on the console confirming that the procedure is
complete.
For more information about the command, see the
Issue the following command to reboot the router's software:
3.
user@host> request system reboot
show system boot-messages
CLI Explorer
and "Installing the Routing Engine in a M7i Router"
CLI Explorer
Copyright © 2019, Juniper Networks, Inc.
command.
.
ad0
.
"Inserting
.