Replacing The Console Or Auxiliary Cable; Figure 50: Console And Auxiliary Serial Port Connector - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide
Related
Documentation

Replacing the Console or Auxiliary Cable

Related
Documentation
148
M7i Chassis Description on page 11
M7i Midplane Description on page 12
Maintaining the M7i Routing Engine on page 192
Removing the PC Card on page 156
Inserting the PC Card on page 157
If a cable is already connected to the
to remove it:
Turn off the power to the console or auxiliary device.
1.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
2.
flat-blade screwdriver if necessary.
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.
To connect the new cable, follow these steps:
Plug the female end of the replacement serial cable into the
1.
port (see "Routing Engine Interface Ports" on page
Tighten the screws on the connector.
2.
Power on the auxiliary or console device.
3.

Figure 50: Console and Auxiliary Serial Port Connector

Fiber-Optic and Network Cable Specifications for the M7i Router on page 91
M7i Chassis Description on page 11
CONSOLE or AUX/MODEM
CONSOLE
145).
Copyright © 2019, Juniper Networks, Inc.
port, follow these steps
or AUX/MODEM