Appendix F M7I Cable Connector Pinouts; Rj-45 Connector Pinouts For The M7I Routing Engine Mgmt Port; Table 27: Rj-45 Connector Pinout; Db-9 Connector Pinouts For The M7I Routing Engine Aux/Modem And Console - Juniper M7I Hardware Manual

APPENDIX F
M7i Cable Connector Pinouts

RJ-45 Connector Pinouts for the M7i Routing Engine MGMT Port

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
RJ-45 Connector Pinouts for the M7i Routing Engine MGMT Port on page 181

DB-9 Connector Pinouts for the M7i Routing Engine AUX/MODEM and CONSOLE

Ports on page 182
RJ-48 Cable Pinouts for E1 and T1 PICs on page 182
The port on the Routing Engine labeled
RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or another device that supports out-of-band management). Table
27 on page 181 describes the RJ-45 connector pinout.

Table 27: RJ-45 Connector Pinout

Pin Signal
1 TX+
2 TX-
3 RX+
4 Termination network
5 Termination network
6 RX-
7 Termination network
8 Termination network
M7i Routing Engine Description on page 18
Maintaining the M7i Routing Engine on page 72
Replacing the M7i Routing Engine on page 97
is an autosensing 10/100-Mbps Ethernet
MGMT
181