Appendix F M10I Cable Connector Pinouts; Rj-45 Connector Pinouts For The M10I Routing Engine Mgmt Port; Table 28: Rj-45 Connector Pinout; Db-9 Connector Pinouts For The M10I Routing Engine Aux/Modem And Console - Juniper M10I Hardware Manual

APPENDIX F
M10i Cable Connector Pinouts

RJ-45 Connector Pinouts for the M10i Routing Engine MGMT Port

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
RJ-45 Connector Pinouts for the M10i Routing Engine MGMT Port on page 201

DB-9 Connector Pinouts for the M10i Routing Engine AUX/MODEM and CONSOLE

Ports on page 202
RJ-48 Cable Pinouts for E1 and T1 PICs on page 202
The port on the Routing Engine labeled
RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing Engine to a
management LAN (or another device that supports out-of-band management). For more
information, see "M10i Routing Engine Interface Ports" on page 17. Table 28 on page 201
describes the RJ-45 connector pinout.

Table 28: RJ-45 Connector Pinout

Pin Signal
1 TX+
2 TX-
3 RX+
4 Termination network
5 Termination network
6 RX-
7 Termination network
8 Termination network
M10i Routing Engine Description on page 15
Maintaining the M10i Routing Engine on page 83
Replacing the M10i Routing Engine on page 131
is an autosensing 10/100-Mbps Ethernet
MGMT
201