FIC Specifications for the M7i Router
Table 33: FIC Specifications
Interface Type
2-port Fast
Ethernet FIC
1-port Gigabit
Ethernet FIC with
SX SFP
1-port Gigabit
Ethernet FIC with
LX SFP
1-port Gigabit
Ethernet FIC with
LH SFP
Related
Documentation
M7i FIC LEDs
Copyright © 2019, Juniper Networks, Inc.
Table 33 on page 45
lists the specifications for the type of network cable accepted by
the FIC. For information about the network cables for the PICs in your router, refer to the
M7i Multiservice Edge Router Interface Module Reference.
Cable
Specification
Cable Supplied
RJ-45
No
connectors (one
for each port);
MDI
noncrossover
Duplex LC
No
Duplex LC
No
Duplex LC
No
M7i PICs Description on page 46
M7i Fixed Interface Card (FIC) Description on page 44
Connecting FIC and PIC Cables to the M7i Router on page 120
Two large alarm LEDs are located on the right of the FIC (see
Figure 15 on page
44). The circular red LED lights to indicate a critical condition that can
result in a system shutdown. The triangular yellow LED lights to indicate a less severe
condition that requires monitoring or maintenance. Both LEDs can be lit simultaneously.
To deactivate red and yellow alarms, you must clear the condition that caused the alarm.
Table 34 on page 46
describes the alarm LEDs in more detail.
Chapter 6: Line Card Components and Descriptions
Maximum
Router
Length
Receptacle
328 ft (100 m)
RJ-45
656 ft/200 m
LC
reach on
62.5/125
micrometer
multimode fiber
(MMF) 1640
ft/500 m reach
on 50/125
micrometer MMF
6.2 mile/10 km
LC
reach on 9/125
micrometer
single-mode
fiber (SMF)
43.5 mile/70 km
LC
reach on 8.2
micrometer SMF
Figure 14 on page 44
and
45