Figure 65: Removing An Ac Power Supply - Juniper M7i Hardware Manual

M7i Multiservice Edge Router Hardware Guide
See Also
178
CAUTION: Do not leave a power supply slot empty for more than a short time
while the router is operational. The power supply must remain in the chassis
for proper airflow.
To remove an AC power supply (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
1.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
Press the power switch on the power supply faceplate to the
2.
NOTE: If you are not removing the power supply, but simply powering it
off, wait at least 60 seconds before turning it back on. If you need to power
it off again, wait for at least 60 seconds after powering it on.
Unplug the power cord from the appliance inlet on the faceplate.
3.
Loosen the thumbscrew at each corner of the power supply faceplate, using a Phillips
4.
screwdriver if necessary.
Grasp the handle on the power supply faceplate and pull firmly to slide the unit about
5.
halfway out of the chassis.
Place one hand under the power supply to support it, then slide it completely out of
6.
the chassis.

Figure 65: Removing an AC Power Supply

Connecting Power to an AC-Powered M7i Router on page 123
Removing an M7i AC Power Cord on page 181
M7i AC Power Electrical Safety Guidelines and Warnings on page 254
Figure 65 on page 178):
Copyright © 2019, Juniper Networks, Inc.
( ) position.
OFF O