Juniper M7i Hardware Manual page 135

Copyright © 2019, Juniper Networks, Inc.
First, perform the following prerequisite procedures:
Verify that the router site meets the requirements described in
Preparation Checklist" on page
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure. For details, see
Requirements" on page
Read the information in
page 225 and "General Safety Warnings for Juniper Networks Devices" on page
Review the guidelines in
Remove the router from the shipping carton, as described in
on page 105.
Then, perform the following procedures to install the router:
NOTE: If you are installing multiple routers in one rack, install the lowest one
first and proceed upward in the rack.
If you are center-mounting the router, move the mounting brackets on the chassis as
1.
described in "Moving the Mounting Brackets" on page
Have one person grasp each side of the router, lift the router, and position it in the
2.
rack.
Align the bottom hole in both mounting brackets with a hole in each rack rail, making
3.
sure the chassis is level.
Install one of the mounting screws provided (in the accessory box shipped with the
4.
router) into each of the two aligned holes. Use a Phillips screwdriver to tighten the
screws.
73.
75.
"General Safety Guidelines for Juniper Networks Devices" on
"M7i Chassis Lifting Guidelines" on page
Chapter 16: Installing the M7i into a Rack
"M7i Router Site
"M7i Router Rack
233.
"Unpacking the M7i Router"
110.
226.
111