Run Mode Display - Siemens Pointek CLS200 Operating Instructions Manual

①
②
③
④
⑤
⑥
⑦
The current software revision is displayed for 1 to 2 seconds at startup on two successive
1)
screens which are immediately followed by RUN mode display.
7.1.2.1

RUN mode display

Measured value display
The default startup display is the measured value display. It shows the value (in counts
when Sensor (Sens) has been selected in Mode 13.
Sensor uncovered
① Communication indicator
② Down arrow indicates alarm output switch
open
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
Primary Reading (displays measured value, or logical level, or an error message)
Auxiliary Reading (displays Units, or the Bar Graph, or Status [error code])
Indicator for Write Protection / Mode number/ Simulation
Down arrow indicates alarm output switch open
Negative sign
Up arrow indicates alarm output switch closed
Communication Indicator - visible only when communications are in progress
7.1 Local User Interface (LUI)
Sensor covered
① Bar graph
Local operation
)
1)
35