Mode 13: Display Source (Default: 0) - Siemens Pointek CLS200 Operating Instructions Manual

Local operation
7.2 Programming via the Local User Interface (LUI)
Protects parameters from unintentional modification. This prevents parameter changes both
locally via the keypad and remotely via SIMATIC PDM. The parameters are still readable.
To enable HW Write Protection:
• Select Mode 10.
• Press ⇑ or ⇓ to activate keylock and to disable operation: L appears in the numerical
value field.
• Press M to exit.
To disable HW Write Protection:
• Select Mode 10.
• Hold ⇑ or ⇓ simultaneously for more than 5 seconds: L disappears from the numerical
value field.
• Press M to exit.
7.2.8

Mode 13: Display Source (default: 0)

Determines which value will be displayed.
To select the display source from the options shown in the table below:
• Select Mode 13.
• Press ⇑ or ⇓ to select the value for the desired source.
• Press M to save the selection and exit.
You can assign the physical unit in Mode 14, if Electronics Temperature is selected as the
display source.
Display Source
From Discrete Input Function Block:
OUT
From Transducer Block: Primary
Value
From Transducer Block: Sensor
Value
From Transducer Block: electronics
temperature: Electronics tempera-
ture
44
Value Auxiliary Units
Reading
0 OUT none
1 PRIM none
2 SENS none
3 TMP E K, °C, °F, or °R Temperature in units
Operating Instructions, 05/2021, A5E47904060-AA
Displayed Value
Bar graph and ON or OFF
Bar graph and ON or OFF
Bar graph and counts value
Pointek CLS200/CLS300 digital