Application Examples - Siemens Pointek CLS200 Operating Instructions Manual

Sections in this manual are designated as follows:
1. Digital: Information is applicable to any CLS200/300 Digital unit (indicated by Digital in the
page footers)
– Pointek CLS200/300 (Page 11) - an introduction to Pointek CLS200/300 Digital model
– Technical data (Page 80)
– Installation (Page 15)
– Technical reference (Page 87)
– Maintenance and repairs (Page 99)
– Hazardous area installation (Page 104)
– Dimensions (Page 116)
– Shortening the cable (Page 138)
2. Standalone: Information is applicable to units installed as a standalone device (indicated by
Standalone in the page footers), and to units installed on a PROFIBUS PA network:
– Wiring (Page 27)
– Local operation (Page 34)
3. PROFIBUS PA: Information is applicable only to units connected to PROFIBUS PA (indicated
by PA on the side tabs and PROFIBUS PA in the page footers).
– Wiring (Page 58)
– Remote operation (Page 62)
– PROFIBUS PA Parameters (Page 71)
– Profibus PA profile structure (Page 100)
For other Siemens level measurement manuals, go to: www.siemens.com/level
(www.siemens.com/level) and look under Level Measurement.
2.1

Application examples

The application examples used in this manual illustrate typical installations using Pointek
CLS200/300; other configurations may also apply.
In all examples, substitute your own application details. If the examples do not apply to your
application, check the applicable parameter reference for the available options.
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
and to the manual
The manual
2.1 Application examples
9