Description; Applications; Mode Of Operation And Diagnosis Leds - Siemens SIMOVERT FC Series Operating Instructions Manual

01.00
1

Description

1.1
The T100 technology board (order number 6SE7090-0XX87-0BB0) is a supplementary board in the SIMOVERT
Master Drives 6SE70 series. It performs various process-related functions depending on the installed software
module. The T100 is inserted in slot 2 (far right) of the electronics box of Master Drives converters FC ,VC, SC
or of an infeed/regenerative feedback unit (see Chapter 2.2). Backplane bus adapter (LBA - Local Bus Adapter)
is required to install the T100 and must be ordered separately under Order No. 6SE7090-0XX84-4HA0.
A software module, which must be ordered separately, is also required to operate the T100. This module is a 40-
pin EPROM module which must be mounted according to the instructions in Chapter 2.2. In addition to the T100,
a communications board (e.g. CB1, SCB1 or SCB2) can be inserted in slot 3 of the electronics box. This board
does not require any additional LBA backplane bus adapter. All relevant signals and parameters of both the
technology board and the basic converter can be accessed via the communications board. The access
mechanism and the unit reactions of the T100 via all serial interfaces are identical to those of the SIMOVERT
Master Drives basic converter.
The T100 has 8 binary inputs, 5 binary outputs, 5 analog inputs, 2 analog outputs as well as two RS 485
interfaces. External signals are connected via screw-type plug-in terminals X130 to X136 on the front plate of the
T100 (see Chapter 3).
The first available software module MS100 "Multi-Purpose Drive" (Order No: 6SE7098-0CX84-0BB0) extends
the basic converter functionality by a large number of drive-related, technological functions such as:
• Higher-level PID controller
• Comfort ramp-function generator
• Comfort motorized potentiometer
• Wobble generator
• 2 serial interfaces
The "Multi-Purpose Drive" software module is described in detail in the "Manual for Software Module MS100
"Multi-Purpose Drive" (Order No. for English version: 6SE7087-6CX84-0BB0).
Other software modules can be found in the appropriate catalog.
1.2

Mode of operation and diagnosis LEDs

The T100 has a high-speed 16-bit processor with its own parameter memory. The T100 is parameterized via the
basic converter, i.e. by means of the parameterizing unit PMU, the optional operator control unit OP1 or via a PC
with the SIMOVIS service program.
The T100 has three diagnosis LEDs which display the following operational states (see Fig. 3.2):
• Red LED flashing (3Hz): T100 is working fault-free in cyclic operation
• Yellow LED flashing (3Hz): Data exchange between T100 and basic converter OK
• Green LED flashing (3Hz): Data exchange between T100 and communications board OK
The T100 is supplied with power via the backplane bus adapter in the electronics box.
Siemens AG 6SE7080-0CX87-0BB0
T100 Technology Board Operating Instructions

Applications

Description
1-1
ENGLISH