Parameters For Local Digital Display; Description Of The Blocks; Transducer Block - Siemens Pointek CLS200 Operating Instructions Manual

Discrete Input Function Block
In the Discrete Input Function Block, the Primary Value is processed further and is adjusted to
the automation task: that is, it looks after conversion, and operations.
The output of this block supplies the measured value and the associated status information to
PROFIBUS PA.
C.2.1

Parameters for local digital display

The values of the following parameters from the measuring and function blocks can be
presented on the digital display. One of the options shown below must be selected in Mode
13: Display Source (default: 0) (Page 44).
Block

Transducer Block

Transducer Block Electronics
temperature
Discrete Input Function Block
C.3

Description of the blocks

C.3.1 Transducer Block
The figure below shows the signal flow of measured values from the sensor through the
Transducer Block into the output value (Primary Value). The parameters of the individual
functions (switch behavior and delay) can be changed via acyclic access (SIMATIC PDM).
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
Parameter
Primary Value
Sensor Value discrete
Sensor Value
Electronic temperature
Output
Profibus PA profile structure
C.3 Description of the blocks
Can be displayed locally
yes
no
yes
yes
yes
101