Profibus Pa Connection To Screw Terminals - Siemens Pointek CLS200 Operating Instructions Manual
Hide thumbs
Also See for Pointek CLS200:
- Quick start manual (200 pages) ,
- Operating instructions manual (129 pages) ,
- Instruction manual (114 pages)
Table of Contents
Advertisement
8.1.1
PROFIBUS PA connection to screw terminals
1. Loosen the lid clip and unscrew the lid of the enclosure.
2. Unscrew and lift up the digital display. (Loosen each screw two turns before completely
loosening both, to keep the rubber retaining rings in place.)
3. Strip the cable jacket for approximately 70 mm (2.75") from the end of the cable, and thread
the wires through the gland.
4. Connect the PROFIBUS PA wires to the terminals shown below (polarity is not important).
The terminal block can be removed and replaced to simplify connection.
5. If you want to use the Alarm Output, connect the wires of an optional input to the Alarm
Output terminals (polarity is not important). The terminal can be removed and replaced to
simplify connection.
6. Ground the instrument according to local regulations.
7. Tighten the gland to form a good seal.
8. Replace the digital display.
9. If you want to adjust the transmitter locally using the keypad, go to Programming via the
Local User Interface (LUI) (Page 38): if not, replace the enclosure lid.
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
8.1 Connecting to a PROFIBUS PA network
Wiring
59
Advertisement
Table of Contents
