Profibus Pa Parameters; Measured Values; Functions - Siemens Pointek CLS200 Operating Instructions Manual

PROFIBUS PA Parameters

It is essential to check settings during the process itself, and confirm that they are correct,
before regular operation commences.
The full range of Pointek CLS200/300 functions is available only via remote operation using
PROFIBUS PA.
To use PROFIBUS PA, you will need a PC configuration tool: we recommend SIMATIC PDM. For
more information see SIMATIC PDM (Page 62).
10.1

Measured Values

In measuring operations, measured values such as the logical level are provided via PROFIBUS
PA. They can be viewed via PROFIBUS PA, and on the LCD display. To view values via
PROFIBUS PA open the menu View – Display, and select one of the following tabs:12
Measured value source
Output
TB
2
TB
2
Electronics Temperature
For instructions on selecting the display source for the LCD, see Display source for local
operation (Page 79).
For more detail see Counts in Counts (Page 88).
1)
TB - Transducer Block
2)
10.1.1

Functions

The device menu gives you access to the following functions:
• Upload from/Download to the device
• Set Address
• Master Reset
• Write Locking
• Sensor Test
• Simulation
• Condensed Status Setup
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
WARNING
Description
Output value On (covered) or Off (uncovered)
Discrete Input Part 2 Discrete Sensor Value On (covered) or Off (uncovered) as well as Primary
Value (On or Off)
Discrete Input Part 1 Sensor value represented in counts
of level as a percentage of the application range.
Internal temperature of the electronics.
10
as well as a dynamic representation
1
71