Location; Mounting; General Safety Instructions - Siemens Pointek CLS200 Operating Instructions Manual

Installation
5.1 Pointek CLS200
Once vertical, CLS200 may be held by the process connection or flange:
①
Note
Unit shown is CLS200 Standard Extended Rod Version. Handling precautions apply to all
CLS200 Standard units with rods longer than 2 m (6.5 ft).
5.1.2

Location

Recommended:
• Provide a sun shield to protect the transmitter from direct heat radiation.
Precautions:
• Avoid mounting Pointek CLS200 in locations subject to strong vibrations in the vicinity,
whenever possible.
• Do not exceed the permissible ambient temperature limits (see Environmental in
Technical data (Page 80) for details).
5.1.3

Mounting

5.1.3.1

General safety instructions

• Installation should only be performed by qualified personnel and in accordance with local
governing regulations.
• This product is susceptible to electrostatic shock. Follow proper grounding procedures.
• The housing may only be opened for maintenance, local operation or electrical
installation.
• Before installing the instrument, verify that the environment complies with any
restrictions specified on the product nameplate.
• To comply with CE EMC regulations, where applicable, the CN 8000 should be installed in
accordance with the testing details listed in Approvals (Page 86).
For additional safety instructions for hazardous locations, see Notes for use in hazardous
locations (Page 104).
16
At the process connection or flange
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA