Lock; Sensor Test; Display Source For Local Operation - Siemens Pointek CLS200 Operating Instructions Manual

10.1.4

Lock

Secures Pointek CLS200/300 from changes.
Parameter name
HW Write Protec-
tion
Write locking
Local Operation
You can also combine the locking functions
HW Write Protection
Off
On
Off
Off
Off
10.1.5

Sensor test

Open the Device Menu to find and activate the Sensor Test via PDM, and to see the results
(test successful, or test failed).
10.1.6

Display source for local operation

You can select one of four options for the value to be displayed on the LCD:
• Output value
• Primary Value
• Sensor Value
• Electronics Temperature.
Go to Local Display and Operation > Display Source and select from the pull-down tab.
The measured value display shows the value (in counts) when Sensor value is selected. The
logical level display shows the value On or Off when Output value is selected. When
communication with a master is in progress, this is indicated by the communication character
o on the digital display. (For more details see RUN mode display (Page 35).)
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
Lock Options
Effect
Parameter changes using SIMATIC PDM, and
settings via local operation, are both disa-
bled. Independent of the other lock func-
tions.
Prevents parameter changes via the bus.
Local operation is possible.
If local operation is disabled, no access is
possible using the keypad. Independently of
this parameter, local operation is automati-
cally enabled 30 s after a communication
failure. Once communication has been
reestablished, the parameter Local Opera-
tion in the device is reset to the original
setting.
Write locking
Off
On or Off
Off
On
On
PROFIBUS PA Parameters
Turn on/off
Keypad Mode 10
SIMATIC PDM
Online dialog:
Write locking
SIMATIC PDM Local
Operation
Local Operation
enabled
enabled or disabled
disabled
disabled
disabled
10.1 Measured Values
Digital
display
L
Lc
LA
Digital display
L
LA
LL
Lc
79