Mode 14: Unit (Default: °C); Mode 15: Node Address (Default: 126) - Siemens Pointek CLS200 Operating Instructions Manual

7.2.9 Mode 14: Unit (default: °C)
Note
Mode 14 becomes available only after Electronics Temperature is selected in Mode 13.
If Electronics Temperature is selected as the display source in Mode 13, you can change the
corresponding physical unit by selecting one of the following options:
Physical Unit
K
°C
°F
°R
To set the physical unit:
• Select Mode 14: the primary reading field displays Unit, and the physical unit appears in
the auxiliary reading field.
• Press ⇑ or ⇓ to select the desired physical unit.
• Press M to save the selection and exit.
7.2.10

Mode 15: Node address (default: 126)

Sets the node address
recommend setting the range between 1 and 125.
To set the PROFIBUS node address:
• Select Mode 15. The current node address is shown in the primary reading field.
• Press ⇑ or ⇓ to open Edit Mode.
• Enter the node address in the permitted range: press ⇑ to change the value of each digit,
and press ⇓ to move the cursor to the next digit.
• Press ⇓ after editing the least significant digit, to terminate the procedure and to save the
value.
• Press M to exit.
Note
• While the device is in cyclic data exchange with a class 1 Master, it is not possible to
change the address. Abort the cyclic communication to change the address.
• Ensure that you set a unique node address to the device. Otherwise, the devices with the
same addresses will cause confusion on the bus.
Applies to PROFIBUS PA applications only. If in standalone application (no network), leave
1)
the node address at the default value.
Pointek CLS200/CLS300 digital
Operating Instructions, 05/2021, A5E47904060-AA
7.2 Programming via the Local User Interface (LUI)
of the device on PROFIBUS. The permitted range is from 0 to 126. We
1)
Display
K
°C
°F
°R
Local operation
45