Alarms - GE Dash 2500 Operator's Manual

Alarms

Name of Alarm
SpO High
2
SpO Low
2
SpO PR High*
2
SpO PR Low*
2
SpO Sensor Disconnected sensor disconnected from
2
SpO Lost Pulse
2
SpO Sensor Off
2
SpO Signal Quality
2
SpO Sensor Faulty
2
* Not active when the View SpO2 PR? option is set to no.
13-18
MASIMO SET® SpO2: Alarms
SpO Alarms
2
Cause
value is greater than "hi"
alarm limit
value is less than "lo" alarm
limit
value is greater than "hi"
alarm limit as set in HR/
Pulse
value is less than "lo" alarm
limit as set in HR/Pulse
module
no or very low SpO signal,
2
signal was lost
SpO sensor has been
2
removed from the patient
low perfusion, excessive
patient movement, too
much ambient light or
interference from another
source is degrading the
quality of the signal
SpO sensor or cable
2
possibly defective, cable not
connected properly
Dash 2500 Patient Monitor
Response
message appears in alarm message
field; parameter label, violated limit (if
limits set to display), and value in
violation flashes in vital signs field
message appears in alarm message
field; parameter label, PR label, violated
limit, violated PR limit (if limits set to
display), and value in violation flashes
in vital signs field
message appears in waveform and
alarm message field; parameter label
flashes in vital signs field
message appears in waveform field,
alarm message field, and in SelectBox
when Enable spot check enable is set
to yes; parameter label flashes in vital
signs field
message appears in waveform field,
alarm message field, and in SelectBox
when Enable spot check is set to yes;
parameter label flashes in vital signs
field
message appears in waveform and
alarm message field; parameter label
flashes in vital signs field
message appears in waveform and
alarm message field; parameter label
flashes in vital signs field
2042480-001 C