Ptx10001-36Mr Network Port Leds - Juniper PTX10001-36MR Hardware Manual

NOTE: The list of ports supported in
example, for port number 4 listed in the table, there are actually three ports numbered 4 on the
PTX10001-36MR (one on each logical PIC) and all three ports support the same speeds.
Table 4: QSFP28 Ports: Supported for 10-Gbps, 25-Gbps, or 40-Gbps Port Speeds
Port Speed Supported Port Number
40 Gbps 4
6
25 Gbps 4
6
10 Gbps 4
6

PTX10001-36MR Network Port LEDs

Each PTX10001-36MR network port uses a single bicolored LED to indicate link status, activity on the
link, or a fault condition. The LEDs for the QSFP28 ports are located above the ports. The LEDs for the
QSFP56-DD ports are located to the left of the ports.
LEDs.
Table 4 on page 13 correspond to 3 logical PICs. For
Corresponding Port Number That Must Be Powerd Off
5
7
5
7
5
7
Figure 5 on page 14 shows the location of the
13