Remove The Dc Power Supply From The Ptx10001-36Mr - Juniper PTX10001-36MR Hardware Manual

4. Using both hands, place the power supply in the power supply slot on the field replaceable units
(FRU) panel of the PTX10001-36MR and slide it in until it is fully seated and the ejector lever slides
into place. See Figure 44 on page
Figure 44: Install a PTX10001-36MR AC/HVDC Power Supply
NOTE: Each power supply must be connected to a dedicated power source outlet.
NOTE: If you have a Juniper Care service contract, register any addition, change, or upgrade of
hardware components at
Failure to do so can result in significant delays if you need replacement parts. This note does not
apply if you replace existing components with the same type of component.

Remove the DC Power Supply from the PTX10001-36MR

WARNING: Turn off the circuit breaker for the DC power source before disconnecting
the power cord from the power supply. Unplugging an DC connection while the power
supply is powered up might damage the electrical connectors.
WARNING: If you need to replace all the power supplies installed in your
PTX10001-36MR, you must power off the PTX10001-36MR before removing the
power supplies. See
111.
https:/ /www.juniper.net/customers/support/tools/updateinstallbase/
"Power Off the PTX10001-36MR" on page
.
100.
111