Table of Contents
Advertisement
3. Align the holes in the mounting rail with the screw holes on the side of the chassis. See
page 82
to see the proper alignment for the PTX10001-36MR.
Figure 23: Attach the Front Mounting Rails to the PTX10001-36MR
4. Attach the mounting rail to the device using the mounting screws. Tighten the screws.
5. Repeat Step
3
and Step
6. Have one person grasp both sides of the device, lift it, and position it in the rack so that the front
bracket is aligned with the rack holes.
7. Have a second person secure the front of the device to the rack by using 4 mounting screws (and
cage nuts and washers if your rack requires them). Tighten the screws. See
Figure 24: Attach the PTX10001-36MR to the Rack
8. Continue to support the PTX10001-36MR while sliding the rear mounting blades into the channel of
the side mounting rails and securing the blades to the rack. Use four mounting screws (and cage nuts
4
on the opposite side of the device.
Figure 23 on
Figure 24 on page
82.
82
Advertisement
Table of Contents
