Table of Contents
Advertisement
The optical interface must meet the requirement FT-1435-CORE in
Fiber Optical Connectors . The module must pass the wiggle test defined by IEC 62150-3.
LC Duplex Connectors
You can use patch cables with LC duplex connectors to connect two supported transceivers of the same
type—for example, 40GBASE-LR4-to-40GBASE-LR4 or 100GBASE-LR4-to100GBASE-LR4. The patch
cable is one fiber pair with two LC duplex connectors at opposite ends. LC duplex connectors are also
used with 12-fiber ribbon breakout cables, as described in
to-LC Duplex Connectors" on page
Figure 22 on page 66
shows an LC duplex connector being installed in a transceiver.
Figure 22: LC Duplex Connector
Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion
IN THIS SECTION
Signal Loss in Multimode and Single-Mode Fiber-Optic Cable | 67
Attenuation and Dispersion in Fiber-Optic Cable | 67
"12-Fiber Ribbon Breakout Cables with MPO-
62.
Generic Requirements for Multi-
66
Advertisement
Table of Contents
