Table of Contents
Advertisement
PTX10001-36MR Network Cable and Transceiver
Planning
IN THIS SECTION
Determine Transceiver Support for the PTX10001-36MR | 58
Cable and Connector Specifications for MX and PTX Series Devices | 59
Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 66
Calculating Power Budget and Power Margin for Fiber-Optic Cables | 68
Determine Transceiver Support for the PTX10001-36MR
The PTX10001-36MR has 36 network ports. The 12 QSFP28 network ports on the port panel support
QSFP+ and QSFP28 transceivers, direct-attach copper (DAC) cables, active optical cables (AOC) , and
DAC breakout cables (DACBO).
The 24 QSFP56-DD network ports on the port panel support QSFP+, QSFP8, QSFP28-DD, and
QSFP56-DD transceivers, direct-attach copper (DAC) cables, active optical cables (AOC), and DAC
breakout cables (DACBO).
See
"PTX10001-36MR Port Panel" on page 7
You can find information about the pluggable transceivers supported on your Juniper Networks device
by using the Hardware Compatibility Tool. In addition to transceiver and connector type, the optical and
cable characteristics—where applicable—are documented for each transceiver. The Hardware
Compatibility Tool enables you to search by product, displaying all the transceivers supported on that
device, or category, by interface speed or type. The list of supported transceivers for the
PTX10001-36MR is located at
CAUTION: The Juniper Networks Technical Assistance Center (JTAC) provides
complete support for Juniper-supplied optical modules and cables. However, JTAC does
not provide support for third-party optical modules and cables that are not qualified or
for more information about the network ports.
https:/
/apps.juniper.net/hct/product/?prd=PTX10001-36MR.
58
Advertisement
Table of Contents
