Table of Contents
Advertisement
Register your product(s) at
Update your installation base at
updateinstallbase.jsp.
Perform the Initial Software Configuration for the
PTX10001-36MR
Before you begin connecting and configuring a PTX10001-36MR, set the following parameter values on
the management console or console server:
• Baud Rate—9600
• Flow Control—None
• Data—8
• Parity—None
• Stop Bits—1
• DCD State—Disregard
You'll need to perform the initial configuration of the PTX10001-36MR through the console port using
the CLI or through zero-touch provisioning (ZTP). To provision the PTX10001-36MR using ZTP, you'll
need access to a Dynamic Host Control Protocol (DHCP) server and a File Transfer Protocol (anonymous
FTP), Hypertext Transfer Protocol (HTTP), or Trivial File Transfer Protocol (TFTP) server on which the
software image and configuration files are stored.
To connect and configure the PTX10001-36MR using the CLI:
1.
Connect the console port to a laptop or PC by using the supplied RJ-45 cable and RJ-45 to DB-9
adapter. The console port (labeled CON/ToD) is located on the management panel of the
PTX10001-36MR (see
2.
Log in as root. There is no password. If the software boots before you connected to the console
port, you might need to press the Enter key for the prompt to appear.
login: root
https:/
/tools.juniper.net/svcreg/SRegSerialNum.jsp.
https:/ /www.juniper.net/customers/csc/management/
"Connect the PTX10001-36MR to a Management Console" on page
98
96) .
Advertisement
Table of Contents
