Connect A Fiber-Optic Cable To The Ptx10001-36Mr - Juniper PTX10001-36MR Hardware Manual

1. (Recommended) Disable the port in which the transceiver is installed by including the disable
statement at the [edit interfaces] hierarchy level for the specific interface:
[edit interfaces]
interface-name disable
set
LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
LASER WARNING: Do not stare into the laser beam or view it directly with optical
instruments even if the interface has been disabled.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
3. Cover the transceiver with a rubber safety cap.
LASER WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.

Connect a Fiber-Optic Cable to the PTX10001-36MR

Before you connect a fiber-optic cable to a PTX10001-36MR, ensure that you have taken the necessary
precautions for safe handling of lasers (see
and "Laser and LED Safety Guidelines and Warnings" on page
The PTX10001-36MR has optical transceivers to which you can connect fiber-optic cables.
To connect a fiber-optic cable to an optical transceiver installed in the PTX10001-36MR:
"Radiation from Open Port Apertures Warning" on page 164
161).
123