Table of Contents
Advertisement
continues to run. Wait at least 60 seconds after first seeing this message before
continuing with this procedure.
3.
4. Disconnect power to the PTX10001-36MR. If the AC power source outlet has a power switch, set it
to the off (O) position. If the AC power source outlet does not have a power switch, gently pull out
the plug end of the power cord connected to the power source outlet.
5. Remove the power source cable from the power supply by pushing in the latch on the side of the
power connector and gently pulling out the power plug from the power supply.
6. Uncable the device before removing it from the rack.
Power Off the DC-Powered PTX10001-36MR
1. Connect to the router by using one of the following methods:
• Connect a management device to the console (COM/ToD) port on a PTX10001-36MR by
following the instructions in
96.
• Connect a management device to the management (MGMT) port by following the instructions in
"Connect the PTX10001-36MR to a Management Ethernet Device" on page
2. Shut down Junos OS Evolved from the external management device by issuing the request system halt
operational mode CLI command. This command shuts down Junos OS Evolved gracefully and
preserves system state information. A message appears on the console, confirming that the operating
system has halted.
user@host> request system halt
Halt the system ? [yes,no] (no) yes
You see the following output (or something similar) after entering the command:
Initiating halt... ok
Initiating Junos shutdown... shutdown: [pid 14318]
Shutdown NOW!
ok
Junos shutdown is in progress...
*** FINAL System shutdown message ***
"Connect the PTX10001-36MR to a Management Console" on page
95.
102
Advertisement
Table of Contents
