Table of Contents
Advertisement
Table 30: 12-Ribbon Patch and Breakout Cables Available from Juniper Networks
Cable Type
Connector Type
24-Fiber MPO Connectors
You can use patch cables with 24-fiber MPO connectors to connect two supported transceivers of the
same type—for example, 100GBASE-SR10-to-100GBASE-SR10.
Figure 21 on page 65
shows the 24-fiber MPO optical lane assignments.
Figure 21: 24-Fiber MPO Optical Lane Assignments
NOTE: Ensure that you order cables with the correct polarity. Vendors refer to these crossover
cables as
key up to key up , latch up to latch up , Type B , or Method B . If you are using patch
panels between two transceivers, ensure that the proper polarity is maintained through the cable
plant.
The MPO optical connector for the CFP2-100G-SR10-D3 is defined in
Hardware Specification and Section 88.10.3 of IEEE STD 802.3-2012 . These specifications include the
following requirements:
• Recommended Option A in IEEE STD 802.3-2012.
• The transceiver receptacle is a plug. A patch cable with a socket connector is required to mate with
the module.
• Ferrule finish shall be flat polished interface that is compliant with IEC 61754-7.
• Alignment key is key up.
Fiber Type
Cable Length
10 m
Section 5.6 of the CFP2
(Continued)
Juniper Model
Number
MTP-4LC-S10M
65
Advertisement
Table of Contents
