Step 6: Connect External Devices And Line Card Cables; Connect To A Network For Out-Of-Band Management; Connect A Management Console - Juniper MX2008 Quick Start Manual

Step 6: Connect External Devices and Line Card Cables

Connect to a Network for Out-of-Band Management

Connect a Management Console

Copyright © 2017, Juniper Networks, Inc.
Figure 33: Connecting External Devices and MPC Cables
Connect to a Network for Out-of-Band Management on page 43
Connect a Management Console on page 43
Connect the Line Card Cables on page 44
Turn off the power to the management device.
1.
Plug one end of an RJ-45 Ethernet cable into the
2.
Plug the other end of the cable into the network device.
3.
CAUTION: You must use shielded cables for the following ports: console,
management, auxiliary, USB, and clocking ports.
Turn off the power to the management device.
1.
Plug one end of an RJ-45 Ethernet cable into the
2.
Step 6: Connect External Devices and Line Card Cables
ETHERNET port on the RCB.
or
CONSOLE AUX
port on the RCB.
43