Step 6: Connect External Devices And Line Card Cables; Connect To A Network For Out-Of-Band Management; Connect A Management Console; Connect The Line Card Cables - Juniper MX2010 3D Quick Start Manual

MX2010 3D Universal Edge Router Quick Start

Step 6: Connect External Devices and Line Card Cables

Connect to a Network for Out-of-Band Management

Connect a Management Console

Connect the Line Card Cables

46
Figure 34: Connect External Devices and MPC Cables
Connect to a Network for Out-of-Band Management on page 46
Connect a Management Console on page 46
Connect the Line Card Cables on page 46
Turn off the power to the management device.
1.
Plug one end of the RJ-45 Ethernet cable into the
2.
Plug the other end of the cable into the network device.
3.
Turn off the power to the management device.
1.
Plug one end of the RJ-45 Ethernet cable into the
2.
Plug the female DB-9 end into the device's serial port.
3.
Have ready a length of the type of cable used by the MPCs or MICs. For cable
1.
specifications, see the
MX Series 3D Universal Edge Routers Line Card Guide
If the cable connector port is covered by a rubber safety plug, remove the plug.
2.
port on the CB-RE.
ETHERNET
CONSOLE or AUX port on the CB-RE.
.
Copyright © 2014, Juniper Networks, Inc.