Table of Contents
Advertisement
CHAPTER 2
Installing the Software
Installing Software on an LN1000 Mobile Secure Router
Related Topics
Setting Non-Volatile Memory Read-Only
Copyright © 2010, Juniper Networks, Inc.
This chapter includes the following topics:
Installing Software on an LN1000 Mobile Secure Router on page 15
Setting Non-Volatile Memory Read-Only on page 15
Installing Software Upgrades from the Network on page 16
Configuring the Software on page 17
The LN1000 router is shipped with the Junos OS preinstalled on the internal NAND flash
drive and ready to configure when you power on the device. A backup copy of the software
is on a USB storage device. You configure the LN1000 router by issuing Junos OS
command-line interface (CLI) commands, either on a console device attached to the
CONSOLE port on the Routing Engine, or over a telnet connection to a network connected
to the Ethernet port on the Routing Engine.
Gather the following information before you configure the device:
Hostname you want to the device to use on the network
Domain name you want the device to use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Junos OS Administration Guide for Security Devices for J Series Services Routers and
SRX Series Services Gateways
Before you upgrade the software or firmware on the LN1000 Mobile Secure Router, the
non-volatile memory read-only (NVMRO) switch must be clear to enable writing to
system storage. NVMRO must also be clear to permanently save any CLI changes.
15
Advertisement
Table of Contents
