Step 8: Perform Initial Software Configuration; Entering Configuration Mode; Configuring User Accounts And Passwords - Juniper MX2010 3D Quick Start Manual

Step 8: Perform Initial Software Configuration

Entering Configuration Mode

Configuring User Accounts and Passwords

Copyright © 2014, Juniper Networks, Inc.
This procedure connects the router to the network but does not enable it to forward
traffic. For complete information about configuring the router to forward traffic, including
examples, see the Junos OS configuration guides.
Check the LEDs on the craft interface to verify the hardware status after reinstalling or
powering on the MX2010 router.
For a list of system status verification commands, see the
at
Hardware Guide http://www.juniper.net/techpubs/
To configure the software:
Entering Configuration Mode on page 63
Configuring User Accounts and Passwords on page 63
Configuring System Attributes on page 64
Committing the Configuration on page 65
Verify that the network device is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0>
login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see authentication.
Add a password to the root administration user account. Enter a clear-text password.
1.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
Create a management console user account.
2.
[edit]
Step 8: Perform Initial Software Configuration
MX2010 3D Universal Edge Router
.
63