Yamaha VK540EF Service Manual page 50

OIL PUMP
10. Remove:
S Bleed bolt 1
S Gasket (bleed bolt)
11. Drain the oil until no more air bubbles ap-
pear from the bleed hole.
12. Inspect:
S Gasket 1 (bleed bolt)
Damage/wear ! Replace.
13. Install:
S Gasket 1 (bleed bolt)
S Bleed bolt 2
14. Install:
S Carburetors
Refer to "CARBURETORS" in CHAPTER 6.
ESS00036
Cable adjustment
NOTE:
Before adjusting the oil pump cable, the throttle
cable distance should be adjusted.
Adjustment steps:
S Pull back the adjuster cover.
S Loosen the locknut 1 .
S Turn the adjuster 2 in or out until the specified
distance is obtained.
Oil pump cable adjusting length a :
24 X 26 mm (0.9 X 1.0 in)
Turning in ! Length a is increased.
Turning out ! Length a is decreased.
S Tighten the locknut 1 and push in the ad-
juster cover.
2-5
INSP
ADJ