Yamaha VK540EF Service Manual page 264

CYLINDER HEAD AND CYLINDER
CAUTION:
S Always use new piston pin clips.
S Do not allow the clip gap to align with the
piston pin slot.
5. Check:
S Piston ring position
CAUTION:
S Make sure that the ring ends are properly
fitted around the ring locating pins in the
piston grooves.
S Be sure to check that the manufacturer's
marks or numbers stamped on the rings
face upward.
6. Install:
S Gasket (cylinder)
7. Install:
S Cylinder
NOTE:
Install the cylinder with one hand while com-
pressing the piston rings with the other hand.
8. Tighten:
S Nuts (cylinder)
NOTE:
Tighten nuts in crisscross pattern.
5-12
ENG
Nuts (cylinder):
25 Nm (2.5 mSkg, 18 ftSlb)