Installation - Yamaha VK540EF Service Manual

CDI MAGNETO
ESS00172

INSTALLATION

NOTE:
After installing all parts, refer to "CABLE ROUT-
ING" in CHAPTER 8, to check the cable, lead
and hose routings.
1. Pass the magneto leads 1 throught the
hole, and install the grommet 2 to the crank-
case.
2. Install:
S Stator assembly 3
NOTE:
Align the timing mark (") 4 on the stator plate
with the seam line 5 of the crankcase.
3. Install:
S Woodruff key 1
S CDI magneto 2
NOTE:
When installing the CDI magneto, make sure
the woodruff key is properly seated in the key
way of the crankshaft. Apply a light coating of
lighium soap base grease to the tapered portion
of the crankshaft end.
CAUTION:
Be sure to remove any oil or grease from the
tapered portion of the crankshaft using a
cloth dampened with thinner.
4. Tighten:
S Nut 1 (CDI magneto)
NOTE:
Attach the universal rotor holder 2 to hold the
CDI magneto.
Universal rotor holder:
90890-01235, YU-01235
Nut (CDI magneto):
85 Nm (8.5 mSkg, 61 ftSlb)
5-22
ENG