Table of Contents
Advertisement
personal use. All data that you have synced from your watch to your Flow account is safe. You can do the factory reset via
FlowSync or from the watch.
Factory reset via FlowSync
1. Go to
flow.polar.com/start
computer.
2. Connect your watch to the computer's USB port.
3. Open settings in FlowSync.
4. Press the Factory Reset button.
5. If you use Flow app to sync, check the list of paired Bluetooth devices on your phone, and remove your watch from
the list if it's there.
Now you need
to set up
the setup you've used before resetting.
Factory reset from the watch
On your watch, go to Settings > General settings > About your watch. Scroll all the way down to find Reset all data and
settings. Press the OK button and then press OK again to confirm the factory reset.
Now you need
to set up
the setup you've used before resetting.
and download and then install the Polar FlowSync data transfer software onto your
your watch again, either via mobile or computer. Just remember to use the same Polar account in
your watch again, either via mobile or computer. Just remember to use the same Polar account in
32
Advertisement
Table of Contents
