Table of Contents
Advertisement
CARING FOR YOUR WATCH
Like any electronic device, your Polar watch should be kept clean and treated with care. The instructions below will help you
fulfill the guarantee obligations, keep the device in peak condition and avoid any issues in charging or syncing.
KEEP YOUR WATCH CLEAN
Wash the watch under running water with a mild soap and water solution after each training session. Wipe it dry with a soft
towel.
Keep the charging contacts of your watch and cable clean to ensure smooth charging and syncing.
Before charging, please make sure there's no moisture, dust or dirt on the charging contacts of your watch and cable.
Gently wipe off any dirt or moisture. Do not charge the watch when it's wet or sweaty.
Keep the charging contacts of your watch clean to effectively protect your watch from oxidation and other possible
damage caused by dirt and salt water (e.g. sweat or sea water). The best way to keep the charging contacts clean is to
rinse the watch after each training session with lukewarm tap water. The watch is water resistant and you can rinse it
under running water without damaging the electronic components.
Take good care of the optical heart rate sensor
Keep the optical sensor area on the back cover scratch-free. Scratches and dirt will reduce the performance of the wrist-
based heart rate measurement.
Avoid using perfume, lotion, suntan/sunscreen or insect repellent on the area where you wear your watch. If the watch
comes into contact with these or any other chemicals, wash it with a mild soap and water solution and rinse well under
running water.
STORING
Keep your training device in a cool and dry place. Do not keep it in a damp environment, in non-breathable material (a
plastic bag or a sports bag) nor with conductive material (a wet towel). Do not expose the training device to direct sunlight
for extended periods, such as by leaving it in a car or mounted on the bike mount. It is recommended to store the training
device partially or fully charged. The battery slowly loses its charge when it is stored. If you are going to store the training
device for several months, it is recommended to recharge it after a few months. This will prolong the battery lifetime.
Do not leave the device in extreme cold (below –10 °C/14 °F) and heat (above 50 °C/120 °F) or under direct sunlight.
SERVICE
During the two-year guarantee/warranty period we recommend that you have service done by an authorized Polar Service
Center only. The warranty does not cover damage or consequential damage caused by service not authorized by Polar
Electro. For further information, see Limited International Polar Guarantee.
For contact information and all Polar Service Center addresses, visit
support.polar.com
and country-specific websites.
PRECAUTIONS
Polar products (training devices, activity trackers and accessories) are designed to indicate the level of physiological strain
and recovery during and after exercise session. The Polar training devices and activity trackers measure heart rate and/or
tell your activity. The Polar training devices with an integrated GPS show speed, distance and location. With a compatible
Polar accessory the Polar training devices show speed and distance, cadence, location and power output. See
www.polar.com/en/products/accessories
for a complete list of compatible accessories. The Polar training devices with a
barometric pressure sensor measure altitude and other variables. No other use is intended or implied. The Polar training
device should not be used for obtaining environmental measurements that require professional or industrial precision.
INTERFERENCE DURING TRAINING
Electromagnetic Interference and Training Equipment
136
Advertisement
Table of Contents
