Setting Up A Computer For Printing/Sending A Fax; Settings From The Operation Panel - Canon imageCLASS MF4690 Reference Manual

Before Using the
Machine 1

Setting Up a Computer for Printing/Sending a Fax

Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
This section describes procedures for Setting Up a computer for
printing/sending a fax.
Before setting up a computer for printing/sending a fax, it is
necessary to perform the following setup procedures.
It is recommended that the network administrator perform the following
procedures.
1.
Network Cable Connection (See "Set the
Machine for Network Usage," in the Starter
Guide.)
Connect the machine to your network using the network cables.
2.
Preparation for Protocol Settings (See "Set the
Machine for Network Usage," in the Starter
Guide.)
Specify the machine's IP address so that the machine and the
network computer can communicate before making protocol
settings. Any of the following can be used to specify the settings.
– Machine's operation panel (Additional Functions menu)
– NetSpot Device Installer (Canon utility software included in the
User Software CD)
Back Previous
3.
Basic Network Settings
Set up the basic network settings between the machine and
computers on your network. To specify the settings, use:
– Machine's operation panel
– Web browser (Remote UI)

Settings from the Operation Panel

■
You can select the printing method over a TCP/IP network.
1.
Press [Additional Functions].
2.
Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using the numeric
keys, then press [Log In/Out (ID)].
3.
Press [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4.
Press [ ] or [ ] to select <TCP/IP SETTINGS>,
then press [OK].
TOP
Next
6-11