Canon imageCLASS MF4690 Reference Manual page 296

Before Using the
Machine 1
Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
No automatic switching between telephone and fax calls.
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q Is paper loaded in the machine?
A Make sure paper is loaded in the machine. (See "Set
Up the Machine, " in the Starter Guide.)
Q Is the telephone cable connected properly?
A Make sure the cable is connected properly. (See "Set
Up the Machine, " in the Starter Guide.)
Q Is the machine set to switch automatically between
telephone and fax calls?
A For the machine to switch between fax and telephone
calls automatically, the receive mode must be set to
<FaxTel>, <AnsMode>, or <DRPD>. If you have set
<AnsMode>, confirm that an answering machine is
connected to the machine and that it is turned on
with an outgoing message properly recorded. (See
"Basic Receiving Method, " on p. 4-35.)
Q Are documents stored in memory, leaving little or
no memory available?
A Print, send, or delete any documents stored in
memory.
Back
Q Has an error occurred during reception?
A Check the LCD for an error message. (See "LCD
Messages, " on p. 10-13.)
A Print an Activity Report and check for an error. (See
"ACTIVITY REPORT, " on p. 11-51.)
Q Is paper loaded in the machine?
A Make sure paper is loaded in the machine. (See "Set
Up the Machine, " in the Starter Guide.)
Q Can the sender's machine send the CNG signal,
which tells your machine that the incoming call is
a fax call?
A Some machines cannot send this signal. In such cases,
receive the fax manually.
Cannot receive a document manually.
Q Is the machine set to receive manually?
A For the machine to receive faxes manually, the receive
mode must be set to <Manual>. (See "Basic Receiving
Method, " on p. 4-35.)
TOP
Previous Next
10-39