Setting Up A Computer For Printing/Sending A Fax; Setting Printing Method - Canon imageCLASS MF7460 Reference Manual

Before Using the
Machine 1

Setting Up a Computer for Printing/Sending a Fax

Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
This section describes procedures for Setting Up a computer for
printing/sending a fax.
Before setting up a computer for printing/sending a fax, it is
necessary to perform the setup procedures described in "Basic
Network Settings," on p. 6-5.
It is recommended that the network administrator perform the following
procedures.

Setting Printing Method

■
You can select the printing method over a TCP/IP network.
1.
Press (Additional Functions).
2.
Press [System Settings] → [Network Settings] →
[TCP/IP Settings] → [▼] → [LPD Settings].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
keys), then press (Log In/Out) to enter the System Settings menu.
The LPD Settings screen appears.
3.
Select [On] or [Off].
[On]: Uses LPD as the print application.
[Off ]: Does not use LPD as the print application.
4.
Press [OK].
5.
Press [RAW Settings].
6.
Select [On] or [Off].
[On]: Uses Raw as the print application. Proceed to step 7.
[Off ]: Does not use Raw as the print application. Skip to step 8.
7.
Select [On] or [Off] for <Use Bidirectional>.
[On]: Establishes bidirectional communication using Port 9100.
[Off ]: Does not establish bidirectional communication using Port
9100.
8.
Press [OK].
9.
Press [Done] repeatedly until the Additional
Functions screen closes.
10.
Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.
– (numeric
Back Previous Next
TOP
6-8