Station Id Lock - Vodavi STARPLUS Triad-S Manual

2-224
Chapter 2 - Features and Operation
Conditions
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.

Station ID Lock

Description
The Station ID Lock feature provides a means for the installer/programmer to lock the station
ID of all stations in the system. After locked, attempts to plug unlike devices (e.g., a DSS into a
24-button port) results in the device not working. This feature is designed to prevent loss of
station programming that results when a different station type is plugged into a port already
designated as another station type.
To change the Station ID with the Station ID Lock feature enabled:
1. Enter programming mode and disable the Station ID Lock feature.
2. Plug the new device type into the jack. The set is automatically identified.
3. Enter programming and perform Station ID programming (FLASH 50, Page B, Button #1).
Set is automatically identified.
4. Enter programming mode and enable the Station ID Lock feature.
Programming Steps
1. Press the STATION ID LOCK flexible button (FLASH 06, Button #8). The following
message displays:
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT ... Station ID Lock feature is disabled.
S TATI ON LO CK
D I S A B LE D
Station Identification
0-1