Incoming Co Line Ringing - Setting Flash Rate; Display Ring Assignments - Vodavi STARPLUS Triad-S Manual

2-72
Chapter 2 - Features and Operation

Incoming CO Line Ringing - Setting Flash Rate

Description
The Incoming CO Line Ringing flash rate is the rate at which an Incoming CO line or Loop
Button flashes. This flash rate can be programmed to 29 different options identified in the
flash rate table, which enables the programmer to customize the key system configuration to
desired flash rates.
Programming Steps
1. Press the INC CO RING flexible button (FLASH 07, Button #1). The following message
displays:
2. Enter a valid number (00-28) on the dial pad that correspond to one of the 29 available
options. (Refer to
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... Incoming CO Ringing flash rate is set for RED 480 ipm Flutter (08).

Display Ring Assignments

Description
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
IN C CO R I NG
RE D 4 8 0 I PM F LU T T E R
Table 2-11 on page
CO L I NE AT TR I B U TE S
S E L E CT A CO LI NE R AN G E
If HOLD is pressed without entering a CO range, ALL CO lines are selected.
X XX - X X X PAG E A
E N T E R B U T TO N N U M B E R
XXX-XXX = CO Line Range
CO Line - Incoming Ringing Assignment
00-28
2-130.)