Vodavi STARPLUS Triad-S Manual page 117

Conference
Operation
To establish a Conference:
1. Lift handset.
2. Select intercom station or dial desired outside party.
3. When called party answers, press the CONF button.
4. Add next conference party by selecting another outside line or intercom station.
5. If the next conference party is an outside line and a busy or wrong number is
encountered, press one of the conference parties on hold. This drops the busy or wrong
number party. Press the conference button again and repeat step 4.
6. When last party answers, press the CONF button twice. (All parties are connected.)
To exit a Conference (controller only) perform ONE of the following:
1 -- Press the ON/OFF button to ON, press MUTE, then replace the handset (to monitor a
conference).
To exit a multi-line conference in progress:
2 -- Press the HOLD button to place outside parties on hold. The Hold Timer starts. If one
of the two parties is internal, that party is dropped.
3 -- Press CONF and hang up or press the ON/OFF button to leave the other conference
parties still connected in an unsupervised conference. The CONF button flashes and the
timer starts. There is a warning tone before the other parties are dropped.
To re-enter a Conference:
When the controller re-enters the conference, the disconnect timer is reset.
1. Lift handset to re-enter a monitored conference.
2. To re-enter a conference placed on hold, repeat steps for establishing a conference.
3. To re-enter an unsupervised conference, lift handset and press flashing CONF button. The
CONF button lights steady and a confirmation tone sounds.
To terminate a Conference, a conference initiator who is active in the conference must:
Replace handset or push ON/OFF button to OFF.
To terminate an Unsupervised Conference:
Press the flashing CONF button while on-hook, all parties are dropped.
To terminate a party from a Conference (while in conference):
1. Press line button of party to drop.
2. Replace handset or press ON/OFF button.
3. Lift handset or press ON/OFF button.
4. Press flashing CONF button.
A maximum of eight parties can be included in a conference.
Chapter 2 - Features and Operation
2-91