Co Line - Identification; Co Line Identification Display - Vodavi STARPLUS Triad-S Manual

CO Line - Identification

5. Enter a valid number on the dial pad (0-23) which corresponds to Groups 0-23.
6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT ... All lines are placed in Line Group 1.
CO Line - Identification
Description
The CO Line Identification feature allows entering a name into the database for each
individual line (trunk) connected to the system. The name may be entered in any
combination up to 12-characters in length (this represents 24 digits entered). When the CO
line identification field is programmed, display telephones receive the identification field in
place of the default field (LINE XXX).
SMDR always print the line number in place of the programmed name. A programmable data
field is available for each line in the system.

CO Line Identification Display

Description
The Co Line Identification Display feature allows the entry of a name for each line (trunk)
connected to the system. Once entered into the database, LCD phones, including the
Attendant stations, receive the programmed line name in place of the default LINE XXX
message. This applies to all line call processing conditions where the current LINE XXX
message displays. SMDR continues to print out the line number in place of the programmed
name. If the line name was not programmed, the current LINE XXX display is the default. A
programmable data field is available for each line in the system. Line names may be assigned
using the range programming.
A message similar to the following display is used for all CO Line displays when a name is
programmed for a CO Line.
L IN E G R O U P
1
LI NE R I NG I NG
nn nn n nn nn nn n
Entries can be made using a keyboard by following the same outlined procedures
Figure C-1: Data Terminal Program Codes Cross Reference
using
Chapter 2 - Features and Operation
0-23
H H : M M am
2-67
.