Vodavi STARPLUS Triad-S Manual page 72

2-46
Chapter 2 - Features and Operation
Operation
To activate a Screened Transfer, (while connected to an outside line):
1. Press DSS button where to transfer call (if programmed on your telephone) or press
TRANS button and dial the station number.
The called extension signals according to the intercom position.
2. When that extension answers, announce the transfer.
3. Hang up to complete transfer.
To answer a Screened Transfer (your intercom will signal according to H-T-P position):
1. Answer the intercom and receive the transfer notice.
2. Press the outside line button or loop button flashing on hold.
To Transfer Search:
When attempting to locate a party, press a DSS button to signal the desired station or press
the TRANS button and dial the desired station number.
If the party is not located:
1. Press another DSS button or press TRANS and dial another station number to continue
the search.
2. When called party answers, hang up to complete the transfer.
To make an Unscreened Transfer:
When called extension begins to signal, hang up to transfer the call (Recall Timer starts).
SINGLE LINE TELEPHONE
To activate a Screened Transfer (while connected to an outside line):
1. Briefly depress and release the hookswitch.
2. Dial desired intercom number.
3. Announce the call.
4. Hang up to complete transfer.
To make an Unscreened Transfer:
1. Briefly depress and release the hookswitch.
2. Dial desired intercom number.
3. Hang up to complete transfer.
To make a PBX/Centrex Transfer:
1. Briefly depress and release the hookswitch. Intercom dial tone sounds.
2. Dial [660]. A Flash command is presented to the PBX or Centrex CO Line (stutter tone
sounds).
3. Dial desired telephone number.
4. Replace handset to complete transfer.
If Direct Transfer Mode is enabled in admin programming, the supervised
transfer is transferred directly to the key station handset.
Call Transfer